How to Use

How To Apply Your Scratch Repair Pen

For the best results, follow these steps carefully before using the pen on your vehicle.

Before first use, the tip needs to be fully saturated with the repair solution by turning the knob on top of the pen.

Remove the cap and brush the tip gently onto a hard surface several times. This allows the liquid to flow into the applicator properly.

Once activated, the tip will change from awhite color to a light yellow shade. This means the pen is ready to use.

Important: Proper activation is necessary for smooth and even application.

Use the pen like a standard nail polish.

Slowly trace over the scratch using light, even strokes. Follow the direction of the scratch and apply only enough product to fill the damaged area.

As you apply, the scratch should become noticeably less visible.

Immediately after application, gently wipe the area using a clean microfiber cloth or soft towel.

This helps remove any excess liquid and blends the finish smoothly into the surrounding paint.

Do not allow excess product to sit before wiping.

Leave the repaired area untouched for approximately 2–3 hours while the formula dries completely.

Once cured, the surface should appear cleaner, smoother, and refreshed.

One pen can repair up to 30 meters of light scratches.
Always close the cap tightly after use to prevent the formula from drying out.
If too much product was applied and has already dried, a small amount of acetone can be used carefully to remove excess residue.